- 地址：
- 安國市南陽工業區
- 電話：
- 18631165157
- 傳真：
- 0312-3427286
- 手機：
- 18631165157
渣漿泵的維修護理包括以下幾個方面 ：
1. 軸承水壓、水量要滿足規定，隨時調整（或更換）填料的松緊程度，切勿造成軸封漏漿。并及時更換軸套。
2. 更換軸承時，一定要保證軸承組件內無塵，潤滑油清潔，泵運行時軸承溫度一般以不超過60-65℃為宜，最高不超過75℃。
3. 要保證電機與泵的同軸度，保證聯軸器中彈性墊完整正確，損壞后應及時更換。
4. 保證泵組件和管路系統安裝正確，牢固可靠。
5. 渣漿泵的部分部件屬于易損件，在日常使用中要關注易損件的損耗情況，及時對其進行維修或更換。渣漿泵易損件維修或更換的過程中要保證裝配正確，間隙調整合理，避免緊澀磨擦現象的出現。
The maintenance and care of the slurry pump includes the following aspects:
1. The water pressure and volume of the bearing should meet the regulations, and the tightness of the packing should be adjusted (or replaced) at any time to avoid leakage of the shaft seal. And timely replace the shaft sleeve.
When replacing bearings, it is necessary to ensure that there is no dust and the lubricating oil inside the bearing components is clean. When the pump is running, the bearing temperature should generally not exceed 60-65 ℃, and the maximum temperature should not exceed 75 ℃.
3. It is necessary to ensure the coaxiality between the motor and pump, ensure that the elastic pad in the coupling is complete and correct, and replace it promptly after damage.
4. Ensure that the pump components and pipeline system are installed correctly, firmly, and reliably.
5. Some components of the slurry pump belong to vulnerable parts, and attention should be paid to the wear and tear of vulnerable parts in daily use, and they should be repaired or replaced in a timely manner. During the process of repairing or replacing vulnerable parts of the slurry pump, it is necessary to ensure correct assembly, reasonable gap adjustment, and avoid the occurrence of tight friction.
上一條：如何正確選擇多吸頭排污泵
